|
This
machine is suitable for grinding a variety of materials:
resin, glass, PC, stone, cutting tools, etc.
It
has High quality material and intelligent design, also, it
is easy to operate. |
|
When this machine is to
be used, connect the hose with the adaptor of the lower
water can. The place the lower water can onto the bottom of
the machine (the water can run out either in the front or at
the back) and lead the drain pipe to the sewer tunnel.
Place the upper water can on the top of the machine and let
in the clean water. When the machine is used for the first
time, take the sponge out from under the water valve, put it
into the water, press it with your hand and the put it back
in its original place after it absorbs enough water. Open
the water valve and let the water drip at 80-100 drops a
minute. Then turn on the switch. The machine is ready to be
used.
If Model W grinding wheel is chosen, the right side will be
rough ground ,and the left side fine ground. When Model WV
grinding wheel is chosen the result with be the same, but
there is also a V-shaped slot to refine the lens
After the machine is used for a period of time, take the
lower water can out and clean it in case the draining hole
should be blocked.
When the grinding wheel has been used for a period of time,
grinding fatigue will appear (failing to grind in). In this
case, use the oilstone stick to recondition the wheel. While
this is being done, open the water valve
The reversible button on the left side of the machine is a
backward or forward adjustor (not used often). When it is
required to run in normal direction or opposite direction,
the chief power switch should be turned off or machine will
be damaged. |
