|
|
|
Steam Generator 4.5KW |
|
This steam generator with the Model of ST-135A
Multi-functional digital controller which is the best suitable for home
SPA. It is very popular in the steam generator industry and can satisfy
most customer’s requirements. |
| Parameters voltage:220V/4.5KW |
| 1 .The steam generator can be installed on the wall or the ground, but
it must be strong. The steam generator is installed in place close to the
tub or in the bathroom as soon as possible. The machine is fixed on one
side of a vertical wall, Loosen the two screws in the machine cover,
remove the cover, there is a hole in the upper left and upper right for
each, which is used to fixed the machine on the wall. After fixing, cover.
2. Forbidden to install the machine in the outdoor, damp places or may
suffer aspic, the corrosion. At the same time it is strictly prohibited
close to flammable and explosive, such as: paint, thinner, gasoline,
etc. Should be placed in dry ventilated place.
3. The steam generator can only be installed horizontally.
|
1. (ON/OFF): Turn and off the steam generator, first press the start of
the steam generator, steam generator is turned off by pressing
again. When you start steam generators, time and temperature display
shows the time and temperature. If the steam room temperature is below
the set temperature, the heat indicator light, if not, the Insulation
indicator light will light.
A: Time Displays window shows the countdown time, if the time shows 0,
the machine will automatically shut down.
B: Temperature display window shows the temperature of the steam room
2. (Setting): Setting the time and temperature of the steam
generator, first pressing is setting the time, and digital time display
flashes inside. The second pressing is setting temperature, the digital
temperature display flashes. Third pressing is to exit setting mode (no
key operations can also be set to exit the state within 15 seconds)
A: In the setting mode, press the up and down keys to adjust the numbers
to time or temperature changes, each time the figure will increase 1 or
subtract 1.
B: Time setting range is 1-60 minutes.
C: Temperature setting range is 35-55℃
D: Timing function uses the countdown time working mode, when showing
0,the machine automatically shut down .
3. When the steam room temperature is higher than the set temperature,
heat indicator light is on, heating light is off, the machine will stop
the steam. Only when the temperature is below the set temperature 2℃, the
machine will continue to produce steam, then the heating light is on,
heat indicator light is off.
|
|
1 set of 4.5KW Steam Generator 153051 |
|
